Introduction
Supplied Components:
| Qty | Name |
|---|---|
| 1 | Cast Acrylic Tube 3” 140mm |
| 2 | O-Ring Flange 3” |
| 1 | 3” End Cap Aluminium - 4 holes |
| 1 | 3” End Cap Aluminium - No holes |
| 1 | Peristaltic Pump |
| 1 | M10 Cable Penetrator - 8mm Cable |
| 1 | M10 Cable Penetrator - 6mm Cable |
| 1 | M10 Cable Penetrator - Blank |
| 1 | Enclosure Vent & Plug |
| 1 | Bladder |
| 2 | M3 Threaded Rod |
| 4 | M3 Nut |
| 1 | Silicone Hose |
| 1 | 6mm Rigid HDPE Pipe |
This guide outlines the parts that come in the kit that are required for the Ballast Tank Assembly. Find these parts and put them aside ready for the assembly guides for the Ballast Tank.
-
-
1 x 3" Cast Acrylic Tube 140mm is required for each of the Ballast Tank Assemblies
-
-
-
2 x 3" O-Ring Flange's are required for each of the Ballast Tank Assemblies
-
-
-
1 x 3” End Cap Aluminium - 4 holes is required for each of the Ballast Tank Assemblies
-
-
-
1 x 3” End Cap Aluminium - No holes is required for each of the Ballast Tank Assemblies.
-
-
-
1 x Peristaltic Pump is required for each of the Ballast Tank Assemblies
-
-
-
1 x M10 Cable Penetrator - 8mm Cable is required for each of the Ballast Tank Assemblies
-
-
-
1 x M10 Cable Penetrator - 6mm Cable is required for each of the Ballast Tank Assemblies.
-
-
-
1 x M10 Cable Penetrator - Blank is required for each of the Ballast Tank Assemblies.
-
-
-
1 x Enclosure Vent & Plug is required for each of the Ballast Tank Assemblies.
-
-
-
1 x Bladder is required for each of the Ballast Tank Assemblies.
-
-
-
2 x M3 Threaded Rod is required for each of the Ballast Tank Assemblies.
-
-
-
4 x M3 Nut is required for each of the Ballast Tank Assemblies.
-
-
-
1 x 1/4" LDPE Tubing is required for each of the Ballast Tank Assemblies.
-
